To change drum rollers on a Kenmore / Whirlpool brand Dryers. You will need to make it look like this.... **First UnPlug electric from the machine
To remove both rollers and stud shafts--- pull the lint filter out if located at on top of the dryer case
Remove 2 screws with a Phillips screw driver from the lint filter area (if located on top--( not the control top )
Lift the front of the top of the dryer (above the door area) while tapping/ pushing the front top case forward (do not push on the control top panel)
Swing the top lid toward the rear- upward movement -out of your way. careful !! not to far, where it would bend the hinge, if falls backwards. We usually have it leaning on a wall or brace it
Unplug the door switch
Remove 2 screws with 5/16 nut driver ( socket) near inside front top area - each side
Hold tub upward slightly - while leaning top front case of unit -(( the door area ))- out toward you, about a inches to 2 inches the most- pull up on front panel to unhook clips from the bottom.
set the panel aside
now you have access to the inside of the dryer
Perfect time to install belt
Replace rollers
or anything else that needs to be done
Parts Parts stores this is one of my favorites parts store. I have personally used them for years, Really Good people.....they have earned the Guru approval
No comments:
Post a Comment
Thank You for your comment or questions. We will be a better source of information if you leave comments. visit us on Facebook.com/FredDiyGuru
Please Click on Google + and Facebook Like -- to help us- be around - to help you !